Venting system of plastic injection mold introduction

Hello everyone, thanks for attention. We’ve discussed about the temperature control system earlier, now we are going to talk about the mold venting information in following 11 articles, from the reason to cause the mold gas, venting type, venting slot designing and so on. Thanks for keep watching!


图片1_(12).png

Related News about USM Injection Mold
  • Slider designing tips 2

    Slider designing tips 2

    Nov 22, 20239. The molding parting surface of the slider molding should be made as a shut-off surface as possible, and the width of the shut-off part should be at least 8mm, and do not make a shut-off surface;...view
  • Plastic injection mold common cooling gate

    Plastic injection mold common cooling gate

    Feb 17, 20221. Straight-through cooling water gate: the straight-through cooling gate is the most commonly used gate for plastic injection mold, and it is also the most convenient type of cooling for processing....view
  • Insert pin of vengting design for molded parts

    Insert pin of vengting design for molded parts

    Mar 20, 2022Insert pin of venting: It is difficult to make exhaust slot when end runner is not in parting surface during injection, and there is no matching gap available, but we could make the venting pin at end...view