0769-8539-0209 / +86-15158220988
Sales@usm-mold.com
En
UNIQUE SOLUTIONS MOLD LIMITED
UNIQUE SOLUTIONS MOLD LIMITED
Car Ceiling Handle Injection Mould
Products
Automotive Ceiling Handle Mold
Automotive Ceiling Handle Mold
Car Ceiling Handle Injection Mould
Car Ceiling Handle Injection Mould
Car Ceiling Handle Injection Mold
Car Ceiling Handle Injection Mold
Automotive Ceiling Handle Mold Car Ceiling Handle Injection Mould Car Ceiling Handle Injection Mold

Car Ceiling Handle Injection Mould

The closer to the cavity wall, the faster the cooling rate, the lower the temperature, and the greater the melt viscosity. The temperature in the center is the highest and the melt viscosity is the lowest. In this way, the injection pressure is always rapidly transmitted through the middle layer, so that the plastic in the center is at the fastest speed.

BUY INJECTION MOLD
Don't Hesitate to Contact Us Now.
Related Gas & Water Assisted Injection Mold
  • The design requirements of slider wear plate
    Jan 03 2024
    The design requirements of slider wear plate
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
  • The T slot of slider and guider designing tips
    Dec 19 2023
    The T slot of slider and guider designing tips
    1. The T slot of slot should be designed according to the picture 1, If there is a relatively high slider, the slider T slot is not high enough which will ...
  • Slider angle designing tips
    Dec 05 2023
    Slider angle designing tips
    1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...
What's New at USM-mold
  • The design requirements of slider wear plate
    Jan 03 2024
    The design requirements of slider wear plate
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
  • The T slot of slider and guider designing tips
    Dec 19 2023
    The T slot of slider and guider designing tips
    1. The T slot of slot should be designed according to the picture 1, If there is a relatively high slider, the slider T slot is not high enough which will ...
  • Slider angle designing tips
    Dec 05 2023
    Slider angle designing tips
    1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...