0769-8539-0209 / +86-15158220988
UNIQUE SOLUTIONS MOLD LIMITED
UNIQUE SOLUTIONS MOLD LIMITED
Plastic Pipe Mold

Plastic Pipe Mold

The gas-assisted controller is used to control the pressure of nitrogen to the mold at different times, the controller is divided into a single air circuit, double air circuit, and four air circuits, each gas path during gas assisted injection moulding can be individually controlled in terms of injection time and injection pressure, the most advanced controllers all use microprocessors in the world, full closed-loop control, and stopless voltage transformation technology.

BUY INJECTION MOLD
Don't Hesitate to Contact Us Now.
Related Gas & Water Assisted Injection Mold
  • The design requirements of slider wear plate
    Jan 03 2024
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
  • The T slot of slider and guider designing tips
    Dec 19 2023
    1. The T slot of slot should be designed according to the picture 1, If there is a relatively high slider, the slider T slot is not high enough which will ...
  • Slider angle designing tips
    Dec 05 2023
    1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...
  • The design requirements of slider wear plate
    Jan 03 2024
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
  • The T slot of slider and guider designing tips
    Dec 19 2023
    1. The T slot of slot should be designed according to the picture 1, If there is a relatively high slider, the slider T slot is not high enough which will ...
  • Slider angle designing tips
    Dec 05 2023
    1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...