0769-8539-0209 / +86-15158220988
Sales@usm-mold.com
En
UNIQUE SOLUTIONS MOLD LIMITED
UNIQUE SOLUTIONS MOLD LIMITED
Water Tank Mould
Products
Concrete Tank Moulds
Concrete Tank Moulds
Water Tank Mold
Water Tank Mold
Water Tank Mould
Water Tank Mould
Concrete Tank Moulds Water Tank Mold Water Tank Mould

Water Tank Mould

Normally, the designer will design the product like normal mold by designing a deformed mold at begining, and then measure the product size after mold trial to make the modification according to the product complexity and different procedure, it will cause the modification take very long time and influence the product quality and delivery time.

BUY INJECTION MOLD
Don't Hesitate to Contact Us Now.
Related Pre-deformation Mold
  • The design requirements of slider wear plate
    Jan 03 2024
    The design requirements of slider wear plate
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
  • The T slot of slider and guider designing tips
    Dec 19 2023
    The T slot of slider and guider designing tips
    1. The T slot of slot should be designed according to the picture 1, If there is a relatively high slider, the slider T slot is not high enough which will ...
  • Slider angle designing tips
    Dec 05 2023
    Slider angle designing tips
    1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...
What's New at USM-mold
  • The design requirements of slider wear plate
    Jan 03 2024
    The design requirements of slider wear plate
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
  • The T slot of slider and guider designing tips
    Dec 19 2023
    The T slot of slider and guider designing tips
    1. The T slot of slot should be designed according to the picture 1, If there is a relatively high slider, the slider T slot is not high enough which will ...
  • Slider angle designing tips
    Dec 05 2023
    Slider angle designing tips
    1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...