0769-8539-0209 / +86-15158220988
UNIQUE SOLUTIONS MOLD LIMITED
UNIQUE SOLUTIONS MOLD LIMITED
PLC Controller Shell Mold

PLC Controller Shell Mold

The assembling for home appliance products are very precise and many products without screws and snaps when assembling, so it means the flatness must be very perfect without warpage, the flatness is basically required to be within ±0.15mm, so the requirements for the mold are very high.,many molds need to be pre-deformed and modified in product size and flatness to ensure product consistency and product size to meet the drawing requirements.


BUY INJECTION MOLD
Don't Hesitate to Contact Us Now.
Related Plastic Household Mould
  • The design requirements of slider wear plate
    Jan 03 2024
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
  • The T slot of slider and guider designing tips
    Dec 19 2023
    1. The T slot of slot should be designed according to the picture 1, If there is a relatively high slider, the slider T slot is not high enough which will ...
  • Slider angle designing tips
    Dec 05 2023
    1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...
  • The design requirements of slider wear plate
    Jan 03 2024
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
  • The T slot of slider and guider designing tips
    Dec 19 2023
    1. The T slot of slot should be designed according to the picture 1, If there is a relatively high slider, the slider T slot is not high enough which will ...
  • Slider angle designing tips
    Dec 05 2023
    1. Normally, all the insertion slopes of the slider are not allowed to be less than 3° to prevent excessive self-locking force and scratched;2. The angle of the locking surface must be bigger than th...