0769-8539-0209 / +86-15158220988
Sales@usm-mold.com
En
UNIQUE SOLUTIONS MOLD LIMITED
UNIQUE SOLUTIONS MOLD LIMITED
Automotive Door Mold
Products
Car Door Mold
Car Door Mold
Car Door Trim Molding
Car Door Trim Molding
Car Door Mold Car Door Trim Molding

Automotive Door Mold

Automotive exterior parts are mainly composed as the following points:

1. Automotive front and rear bumper, the main products are bumper, grille, trailer cover, etc.;

2. Automotive mudguard, the main products are automobile mudguard;

3. Automotive lamp assembly, the main products are BMC Reflector/PC HL Lens and Multicolor Lens/Head Lamp Bezel/Head and Tail Lamp Housing/Multicolor Lens/Rear Lamp Bezel/Tail Lamp Housing\Adjustment Elements and so on.


BUY INJECTION MOLD
Don't Hesitate to Contact Us Now.
Related Automotive Mold
  • The common fixing method of angle pin
    May 11 2024
    The common fixing method of angle pin
    The angle pin is a common part of the drive slider, and the fixing and installation methods as following:1. Pass through the mold plate directly and press the angle pin with the top plate to fix it, a...
  • Slider spring hength and strength calculation
    Apr 23 2024
    Slider spring hength and strength calculation
    Processing size:1. ØD2=ØD+22. Ll = total spring length (L) - preload value of spring (N) - slider core pulling distance (L2)Spring length calculation: (refer to picture 1 for length calculation)★L...
  • The design requirements of slider wear plate
    Jan 03 2024
    The design requirements of slider wear plate
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...
What's New at USM-mold
  • The common fixing method of angle pin
    May 11 2024
    The common fixing method of angle pin
    The angle pin is a common part of the drive slider, and the fixing and installation methods as following:1. Pass through the mold plate directly and press the angle pin with the top plate to fix it, a...
  • Slider spring hength and strength calculation
    Apr 23 2024
    Slider spring hength and strength calculation
    Processing size:1. ØD2=ØD+22. Ll = total spring length (L) - preload value of spring (N) - slider core pulling distance (L2)Spring length calculation: (refer to picture 1 for length calculation)★L...
  • The design requirements of slider wear plate
    Jan 03 2024
    The design requirements of slider wear plate
    1. The wear plate of slider requires hardening treatment, with a hardness of 45-48HRC;2. The friction surface of the wear plate is required to be 1.0mm higher than the slider surface (see picture-1);3...