0769-8539-0209 / +86-15158220988
En
UNIQUE SOLUTIONS MOLD LIMITED
UNIQUE SOLUTIONS MOLD LIMITED
Air Chamber Mold

Air Chamber Mold

Some mold factories will make CAE analysis at begining and then make pre-deformation mold design according to the deformation data from CAE report, but the value is different betwen actual and thoery. so the engineer will think the mold flow analysis is not accurate, but in our opinion, CAE data can be used but it depends on how to read the deformation value.


BUY INJECTION MOLD
Don't Hesitate to Contact Us Now.
Related Pre-deformation Mold
  • Slider designing tips 2
    Nov 23 2023
    The molding parting surface of the slider molding should be made as a shut-off surface as possible, and the width of the shut-off part should be at least 8mm, and do not make a shut-off surface;When u...
  • 2022 Shenzhen Industrial Exhibition ITES ended successfully
    Aug 22 2022
    The 2022 ITES Shenzhen International Industrial Manufacturing Technology and Equipment Exhibition and the 23rd Shenzhen International Machinery Manufacturing Exhibition were grandly opened in Shenzhen...
  • Slider designing tips 1
    Aug 04 2022
    1. After the slider core pulls out, the length of staying in the guide pin slot should not be less than 2/3 of the total length of the slider, for special cases, the slider slot can be partially lengt...
  • Slider designing tips 2
    Nov 23 2023
    The molding parting surface of the slider molding should be made as a shut-off surface as possible, and the width of the shut-off part should be at least 8mm, and do not make a shut-off surface;When u...
  • 2022 Shenzhen Industrial Exhibition ITES ended successfully
    Aug 22 2022
    The 2022 ITES Shenzhen International Industrial Manufacturing Technology and Equipment Exhibition and the 23rd Shenzhen International Machinery Manufacturing Exhibition were grandly opened in Shenzhen...
  • Slider designing tips 1
    Aug 04 2022
    1. After the slider core pulls out, the length of staying in the guide pin slot should not be less than 2/3 of the total length of the slider, for special cases, the slider slot can be partially lengt...