Amazing Outdoor Traveling
Our team experienced wonderful outdoor walking a few weeks ago. we took a big bus from our office to the destination which is very natural and frosty with a very clean river dotted with cobblestones. we walked through the small rivers by naked feet. the cool water penetrates the cool from our feet to our head completely, the dotted cobblestones keep our feet massaged hardly, we look as the adventurers who walk through the forest. we check in the hotels later and took hot springs there which relax us a lot.
Everyone to Daro Yi Love Valley Hot Spring Resort Hotel, the early lights of Yi Love Valley is another beautiful scenery, surrounded by green bamboo trees, along the river on both sides of the cliff, jagged rocks, canyon path, trees as if the work of a ghost. In the scenic area of 4 square kilometers, the surrounding mountains, butterflies fluttering, beautiful and charming scenery. The terrain of the scenic area is varied, and the mountains and water form a multi-level beautiful painting. After a short rest, we enjoyed a sumptuous dinner arranged in advance by the hotel and prepared for tomorrow's rafting.
The happiest thing is rafting, from the starting point of the rafting: the romantic cosy through the time tunnel, a 36-meter drop of the waterfall rapid wander curb flying boat, along with the wooded waterway ups and downs downstream straight, sometimes rapids surging, blimp surfing; sometimes gentle as the main, flood boat play water; unspeakable "stimulation and release of" feeling. .... All colleagues sometimes rafting hard forward, and sometimes stop to fight the water, are bathed in the romantic and happy between the landscape.


What is Called Draft Angle?
Dec 29, 2021The draft angle is also called demold angle and angle which is used for product removal from the mold and designed on the parting surface, the angle is called draft angle which shows in picture 1....view
The sub gate of the plastic injection mold runner system
Jan 26, 2022In order to get the best injection quality, the gate type must be selected carefully, the coommon gate tyeps are: direct gate, side gate, pin-point gate, sub gate,valve gate of hot runner etc. Among...view_20250317091113A018.jpg)
The basic points of designing gas-assisted injection molding
Apr 17, 20221. Firstly, considering the suitable wall thickness areas needs to be injected and hollowed out, and then decide how to connect them with the gas channel; 2. The gas channel should be arranged in...view
Limitations of gas-assisted injection molding technology
Apr 25, 2022Gas-assisted injection molding technology has obvious advantages in thick wall thickness and pipe parts, but this technology still has many limitations, which are mainly reflected in the following...view
The difference between full shot and short shot of gas-assisted injection molding
Apr 13, 2022Gas-assisted injection molding can be divided into short shot and full shot. Short shot The short shot method is shown in picture 1, it is suitable for thick-walled plastic parts with low mold filling...view
The common fixing method of angle pin
May 10, 2024The angle pin is a common part of the drive slider, and the fixing and installation methods as following: 1. Pass through the mold plate directly and press the angle pin with the top plate to fix it,...view
English
русский

_20250310164515A048.webp)

